Engine oil and its additives tend to age, so timely and regular oil changes are necessary for the engine for healthy blood! So today I will tell you in detail how to change the oil and Choose Oil for 4.3 Vortec.
What You Need for Oil Changes
You will need:
- A canister of fresh oil
- Filter
- To unscrew the crankcase protection – a wrench of the right size depending on the car
- To unscrew the drain plug, the same wrench is usually sufficient, but in some models, you can find a hexagon or star-torx
- A drip pan or old canister with the side cut off is good for draining used oil
- New drain hole gasket – multilayer washer
How to Change Oil
-
Remove the protection – there is no universal advice, it all depends on the make and model of your car.
-
Put the pan and unscrew the drain plug. Be careful at the moment when the old oil pours out – you could get burned.
-
If you are not planning to do any other work with your car right now, you can take off the cap of a neck where you fill up the oil – some believe it will drain faster. But it is fraught with danger – dust or other debris may get into it.
-
Take your time – at first the best winter oil for 4.3 vortec will flow quickly, then the process will slow down. You need to wait until the drain is drained.
Preparing to Fill with New
Remove the oil filter. Sometimes it is difficult to do this by hand, so use improvised means. It is better to take a special puller for your model – it is practiced in car repair shops, it is fast and safe. Or pick up the filter with something thin and sturdy, but be careful – the tool might pop off and damage something.
When the filter is removed, screw in the drain plug right away – put a new gasket, tighten. Note, you don’t have to apply much force – one of the popular problems with oil changes is a torn hole head.
Install A New Filter
Put in a new filter. Fill the filter with new oil is not necessary – it makes no sense, although such advice can be found among old car owners “Zhiguli”. Moreover, in many cars the filters are placed at an angle, and the oil will leak out. Dab some oil on the rubber band of the new filter, screw it in by hand. The process shouldn’t be difficult – if it’s difficult, add oil to the rubber band.
Pour in Oil
In the service, new best oil for chevy vortec 4.3 is poured with a hose – it will turn out neat. In the garage you can use a funnel. Note – you don’t have to pour in as much oil at once as indicated by the volume of the crankcase. In fact, you have not drained all the oil, something remains. Pour a little less and wait about 10 minutes for the oil to drain out. Use the oil recommended by the manufacturer.
Check the Level
Fill up with oil based on the upper marking on the dipstick. If doing it for the first time, study the instructions and consult an expert – some cars should keep the boundary short of the maximum mark halfway down the dipstick, while others keep it near the top mark.
That’s It!
Watch the mileage, check the service interval according to the manufacturer’s instructions. Change oil more often, so the engine will live longer. And I hope you enjoyed this article!
